红外菲涅尔透镜的注射超声辅助成型优化

为了提升聚合物红外菲涅尔透镜的光学性能,以其表面微沟槽的成型质量为目标,提出了一种高效的注射超声辅助成型方法,并对工艺参数进行了综合质量优化。首先分析了超声振动对聚合物的加热和加压效应,设计了一套一模两腔的对比试验模具;接着以红外菲涅尔透镜的调制传递函数MTF和齿形平均高度h为优化质量目标,设计了四步骤的多目标优化流程,通过试验设计、基于BP神经网络的质量目标与注射工艺参数关系建模、基于NSGA-Ⅱ的多目标优化和试验验证进行工艺参数的综合优化。实验结果表明:该多目标优化流程具有很高的精度,MTF和h的平均预测误差MPE分别为4.16%和3.32%;注射超声辅助成型的菲涅尔透镜微沟槽具有更高的复制质量,其齿沟槽平均高度h增加了15.6%,且h值的波动量随着h值的增大而增大,MTF值受齿高h均匀性的影响大于齿高h对其的影响。     

引江济巢工程对改善巢湖水质的数值模拟分析

巢湖受周围城市工业化及农业生产迅速发展的影响,湖区及流域的生态环境发生了巨大变化,尤其是近几年巢湖水质达到重富营养化水平。引江济巢工程是改善巢湖水质的重要工程措施,采用EFDC生态动力学模型模拟了巢湖不同调水流量、调水线路、调水时间对水环境的影响。结果表明,引江济巢工程在一定程度、时间上使巢湖湖区水质发生一定程度的改善,但若入湖水质不达标,调水也增加了巢湖的富营养化风险。     

Real‐time thermal states monitoring of absorber tube for parabolic trough solar collector with non‐uniform solar flux

With the world energy shortage problem becoming increasingly prominent, more and more attentions have been paid to the development of renewable energies. Among these sources, solar energy has received extensive attention with its excellent characteristics. The thermal state affects the safety of the solar heat collection system. In this paper, real‐time monitoring of the input heat flux on the inside wall and the temperature field simultaneously of an absorber tube for parabolic trough solar collector were studied. Based on the measured temperatures on the outside wall, the fuzzy adaptive Kalman filter coupled with weighted recursive least squares algorithm (WRLSA) was employed to monitor the heat states of the absorber tube inversely, in which WRLSA was used to acquire the heat flux while fuzzy adaptive Kalman filter was adopted to monitor the temperature field. The method showed strong robustness to resist the ill‐posedness. Accurate monitoring results also can be acquired when there are random disturbances of the heat transfer condition on the inner wall.     

Enhanced oil recovery from carbonate reservoirs by spontaneous imbibition of low salinity water

An experimental study was performed to investigate the impact of low salinity water on wettability alteration in carbonate core samples from southern Iranian reservoirs by spontaneous imbibition. In this paper, the effect of temperature, salinity, permeability and connate water were investigated by comparing the produced hydrocarbon curves. Contact angle measurements were taken to confirm the alteration of surface wettability of porous media. Oil recovery was enhanced by increasing the dilution ratio of sea water, and there existed an optimum dilution ratio at which the highest oil recovery was achieved. In addition, temperature had a very significant impact on oil recovery from carbonate rocks. Furthermore, oil recovery from a spontaneous imbibition process was directly proportional to the permeability of the core samples. The presence of connate water saturation inside the porous media facilitated oil production significantly. Also, the oil recovery from porous media was highly dependent on ion repulsion/attraction activity of the rock surface which directly impacts on the wettability conditions. Finally, the highest ion attraction percentage was measured for sodium while there was no significant change in pH for all experiments.     

Large scale cathodic exfoliation of graphite using deep eutectic solvent and water mixture

A short-time and low-cost synthesis route was used to produce large lateral size (from 2 to 15 μm) from monolayers to few layers of graphene by a two-step process of electrochemical exfoliation with a deep eutectic solvent in a mixture with water that can be reused, and ultrasonic bath. The graphene was characterized by SEM, TEM, AFM, Raman and electrochemical activity. During the electrochemical exfoliation, high expanded graphene particles were obtained and these were dispersed in a mixture of water with 5%wt ethylene glycol by an ultrasonic bath in order to complete the exfoliation process. An enhancement of the electrical conductivity of these dispersions was obtained with the increase of graphene concentration, 0.38 mg/mL, which best result was achieved with 30 wt% water and a DC voltage of 10 V. It was possible to add a conductive layer to a glass substrate with the graphene obtained and Tyndall effect was observed.     

课程群案例嵌入协同教学模式的探索

在课程群的教学中由于每门课程各自独立开展教学,缺乏知识的融合和衔接,导致学生运用综合知识解决问题的能力较弱。在课程群的教学中采用案例嵌入协同教学模式,将完整的工程案例嵌入到课程群各门课程的教学中,协同规划各门课程的教学任务,每门课程再围绕案例展开研究性教学。通过嵌入的工程案例衔接各门课程的知识点,帮助学生建构完整的知识体系,强化工程应用的概念；同时通过研究性教学,培养学生分析问题和解决问题的能力,两部分相结合,提高了学生运用综合知识解决复杂问题的能力。     

综采工作面活性磁化水防尘技术研究

煤矿生产是环境较为封闭的井下作业，具有一定的特殊性，作业空间湿度高、生产环境复杂，其中粉尘是危害最大的因素之一，会对机器和人体造成不同程度的损害。粉尘的危害主要由两方面决定:煤尘能够燃烧，在浓度较高时还会爆炸；粉尘会危害人的身体健康。以平煤股份十矿-320 m水平己四采区东翼下段的己_15-16-24130工作面为研究对象，研究磁化水除尘的方法及原理，通过对比分析优选出活性磁化水添加剂，在该工作面试验后具有良好的除尘效果，大大增加了可见度、降低了空气中悬浮的煤尘。研究对该矿井其他工作面除尘工作具有指导意义。     

采煤工作面煤层注水工艺优化与应用

针对目前煤层注水存在的施工钻孔效率低、钻孔深度达不到要求、注水钻孔封孔不严、封孔器回收困难等问题，研究注水工艺的改进优化，对钻机、钻具及封孔器进行重新设计选型，形成了一整套的注水装备。该装备的应用提高了施工效率，为降低工作面粉尘危害、抑制工作面瓦斯涌出、防治煤炭自然发火等危害探索出了更加高效的途径和方法。现场应用表明，煤层注水有效地改善了工作面作业环境，为工作面实现高产高效奠定了基础。     

纳米纤维素的疏水改性及应用研究进展

纳米纤维素作为一种性能优越的可再生纳米材料，应用前景极为广阔。然而，由于纳米纤维素结构上富含羟基，使其具有极强的亲水性，严重影响了纳米纤维素的疏水性能，并且在一定程度上限制了其在复合材料领域的应用。综述了纳米纤维素疏水改性的研究进展，从物理吸附、表面化学修饰（甲硅烷化、烷酰化、酯化等）、聚合物接枝共聚3个方面简述了目前应用较为广泛的疏水化改性方法，并对疏水纳米纤维素在包装材料、造纸、水净化等方面的应用现状进行了总结。最后对疏水改性纳米纤维素的未来发展进行了展望，旨在为疏水纳米纤维素的研究和应用提供参考。